Catalog of brush cleaning designs

Six designs, each with a diagram, variants, and the dimensions a technical request needs. No product listings or prices: this is a reference site.

Complete brush cleaners

Complete belt cleaning units: what the assembly includes, drive and mounting options, and which dimensions to request from a manufacturer.

Roller brushes for conveyor belts: working and total length, outside diameter, core and seating, filament and its replacement.

Sectional brushes: sections mounted on a common shaft, layout along the length, replacing individual sections, and design limits.

Replacement elements for brush cleaners: filament, holders, frames; how to check fitting dimensions before ordering.

Cleaning chevron and profiled belts: ribs, profile pitch, and how the filament reaches the surface between ribs.

Ordering brushes to customer dimensions: which measurements and data to include in a technical request so offers are comparable.

Broad differences between families — an editorial comparison, not technical compatibility.

Family	Strength	Keep in mind
Complete cleaners	A finished unit: roller, bearings, drive	Check fitting and mounting dimensions
Roller brushes	Even contact along the full belt width	Full replacement when filament wears along the length
Sectional brushes	Replace sections individually, stack to length	Section joints, layout along the shaft
Replacement elements	Refresh filament without replacing the roller	Holders and frame must match the unit
For chevron belts	Works with the belt profile	Rib pitch and height change contact conditions
Made to measure	Fits a non-standard unit	Quality depends on how complete the request data is

The table can be scrolled horizontally.

The minimal set of dimensions without which any offer will be imprecise.