From taken dimensions
You provide measurements from the unit: diameters, lengths, seatings; the measurement map is G09 in the assistant.
Made-to-measure brushes
When a standard design does not fit, a brush is made to the unit: from taken dimensions, a drawing or a sample. Offer quality depends directly on how complete the request data is.
Ways to order
From a drawing
A sketch or drawing with dimensions and materials; tolerances are agreed with the manufacturer.
From a sample
A worn brush or its fragment as the sample, complemented by operating condition data.
What to include in the request
Data set for a made-to-measure brush order
| Section | What to state |
|---|---|
| Geometry | All dimensions from the measurement map: diameter, core, lengths, seatings. |
| Filament | Material (PP/PA), intended free length — with a note that the manufacturer selects the final value. |
| Operating conditions | Material, moisture, temperatures, speeds, chevron — as in the assistant. |
| Special requirements | Food contact, aggressive media, explosive atmospheres — need documented execution. |
The table can be scrolled horizontally.
Limits and caveats
- The site does not manufacture or approve designs; the request is a document for a manufacturer.
- Special executions (food, ATEX, aggressive media) must be documented.
- Comparable offers come from equally complete data in every request.
When this is appropriate: A non-standard unit, a non-standard belt, or the need to reproduce a worn brush exactly. If a standard design fits, it is usually cheaper and faster to buy.
Related pages
A technical request for brush manufacturing
The quality of a manufacturer offer directly depends on the completeness of your request. A good specification is short but contains all dimensions, conditio…